2 The parameters for the CNC and PMC are factoryset. Operating the machine with incorrectly specified data may result in the machine behaving unexpectedly, possibly causing damage to the workpiece and/or machine itself, or injury to the user. WARNING 1 Before operating the machine, thoroughly check the entered data. GENERAL WARNINGS AND CAUTIONSThe following warnings and note describe precautions on handling CNCs, which must be observed to ensure safety when using machines equipped with a CNC.
#Fanuc fapt ladder iii manual#
NOTE Notes is used to indicate supplementary information other than Warnings and Cautions.- Read this manual carefully, and store it in a safe place. CAUTION Applied when there is a danger of the equipment being damaged, if the approved procedure is not observed. WARNING Applied when there is a danger of the user being injured or when there is a danger of both the user being injured and the equipment being damaged if the approved procedure is not observed. Read the Warnings, Cautions, and Notes thoroughly before attempting to use the machine. Also, supplementary information is described as Notes. Precautions are classified into Warnings and Cautions according to their bearing on safety. SAFETY PRECAUTIONSThis manual includes safety precautions for protecting the user and preventing damage to the machine. However, these names are not followed by or in the main body. This manual contains the program names or device names of other companies, some of which are registered trademarks of respective owners. Therefore, matters which are not especially described as possible in this manual should be regarded as impossible. However, we cannot describe all the matters which must not be done, or which cannot be done, because there are so many possibilities. In this manual we have tried as much as possible to describe all the various matters. The export of this product is subject to the authorization of the government of the country from where the product is exported. All specifications and designs are subject to change without notice. No part of this manual may be reproduced in any form. No warranties of merchantability or fitness for purpose shall apply.Ĭopyright 2002 GE Fanuc Automation North America, Inc. GE Fanuc Automation makes no representation or warranty, expressed, implied, or statutory with respect to, and assumes no responsibility for the accuracy, completeness, sufficiency, or usefulness of the information contained herein. GE Fanuc Automation assumes no obligation of notice to holders of this document with respect to changes subsequently made.
#Fanuc fapt ladder iii software#
Features may be described herein which are not present in all hardware and software systems. While efforts have been made to be accurate, the information contained herein does not purport to cover all details or variations in hardware or software, nor to provide for every possible contingency in connection with installation, operation, or maintenance. This document is based on information available at the time of its publication. NoteNotes merely call attention to information that is especially significant to understanding and operating the equipment. In situations where inattention could cause either personal injury or damage to equipment, a Warning notice is used.ĬautionCaution notices are used where equipment might be damaged if care is not taken. Warnings, Cautions, and Notes as Used in this PublicationWarningWarning notices are used in this publication to emphasize that hazardous voltages, currents, temperatures, or other conditions that could cause personal injury exist in this equipment or may be associated with its use. Ladder-IIIOperators ManualGFZ-66234EN/04 December 2002 GE Fanuc AutomationComputer Numerical Control Products